COULD NOT DUPLICATE CUSTOMER CONCERN, TEST DROVE VEHICLE 2 TIMES, ONCE WITH GUEST PERFORMED LIVE DATA READ NO MISFIRE, NO CODES, NOTHING IN HISTORY. WAS ABLE TO READ ALL DATA IN VEHICLE. VEHICLE HAS NORMAL OPERATION AT THIS TIME
LARRY L. gave our service a 5 star review on 1/19/2021
Replace Engine Oil & Filter Rotate Tires Check And Adjust Pressures Inspect Air Conditioning Filter Inspect Engine Air Filter Inspect Drive Belts Inspect Drive Shaft Boots (Re-Torque Flange Bolts) Inspect Ball Joints & Dust Covers Inspect Brake Linings & Discs/Drums Inspect and Fill Fluid Levels Inspect Body/Chassis Nuts & Bolts Inspect Steering Linkages Reset Maintenance Light Road Test Vehicle
REPLACED RACK AND PINION
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
STABILIZER BAR CONTROL LINK REAR – Remove & Replace – Both REAR
TIE ROD &/OR END – Remove & Replace – Front,Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some mode
CHARLIE B. gave our service a 5 star review on 1/19/2021
DURING INSPECTION FOUND BATTERY TERMINAL ENDS ARE LARGE ON BATTERY POST, THAT A PIECE OF LEAD WAS ADDED TO BOTH TERMINAL ENDS. (LEAD WAS THERE PTS) LOOSEN, CLEANED AND RE TIGHTEN BATTERY TERMINALS. RE-TESTED BATTERY, BATTERY PASSED. AFTER FINAL TEST FOUND A NO START CONDITION THAT WAS A STARTER FAILURE.
STARTER ASSEMBLY – Remove & Replace – All Applicable Models
WILLIAM W. gave our service a 5 star review on 1/5/2021
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
TIE ROD &/OR END – Remove & Replace – Inner,Both – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing I
NANCY N. gave our service a 5 star review on 12/23/2020